高校问答rebecca more:汉译英 谢谢你！！（人工翻译）
来源：百度文库 编辑：高校问答 时间：2024/04/25 21:16:18
Troubleshooting problems
The message file is an iteration by iteration account of the simulation. It shows how close each iteration is to converging to the final solution by calculating a relative error norm between successive steps for both nodal velocities and nodal forces. There is also information given on node contact being generated and also if there is a sudden stop. The log file is an account of the module execution
Message file messages
If a simulation stops early, it is recommended to check the end of the message file to see why the simulation stopped. While a simulation is run under the batch mode of operation, there are three places in which the end of operation may be indicated. The message file is where the simulation will indicate a normal stoppage of the FEM module. If there is an abnormal stoppage in simulation, due to an illegal operation in the FEM module or in the mesh generation, this will be indicated in either the .LOG file or in the command window where DEFORM was intially called. This may be also accompanied by a core file which should be deleted as soon as possible since they often consume a large amount of disk space.
OK
The message file is an iteration by iteration account of the simulation. It shows how close each iteration is to converging to the final solution by calculating a relative error norm between successive steps for both nodal velocities and nodal forces. There is also information given on node contact being generated and also if there is a sudden stop. The log file is an account of the module execution
Message file messages
If a simulation stops early, it is recommended to check the end of the message file to see why the simulation stopped. While a simulation is run under the batch mode of operation, there are three places in which the end of operation may be indicated. The message file is where the simulation will indicate a normal stoppage of the FEM module. If there is an abnormal stoppage in simulation, due to an illegal operation in the FEM module or in the mesh generation, this will be indicated in either the .LOG file or in the command window where DEFORM was intially called. This may be also accompanied by a core file which should be deleted as soon as possible since they often consume a large amount of disk space.
OK
故障修理问题
信息文件是模拟的重复帐户的一个重复。 资讯科技表示如何结束每个重复是到藉由为节的速度和节的军队计算在连续的步骤之间的一个比较的错误基准对最后解决聚合。 也有被给在节上连络被产生的数据以及如果有一个突然的停止。 圆木文件是组件实行的一个帐户
信息申请信息
如果一个模拟停止得早,它被推荐检查信息文件的结束见到模拟为什么停止。 一个模拟被操作的一届模态支配, 有三个地方在哪一操作的结束可能被指出。 信息文件是模拟将会指出 FEM 组件的一个正常中止的地方。 如果有模拟的一个不正常的中止, 在 FEM 组件中或在网孔世代中由于违法的操作，这将会在任一被指出那。伐木文件或在指令窗户中哪里使是被叫做的 intially变形。 因为他们时常消费很多的磁盘片空间，这也可能随同一个应该尽快地划除的核心文件。