貂皮大衣保养:网卡、交换机、网线经检测全部正常,但是三者连上之后网卡和交换机指示灯均不亮?

来源:百度文库 编辑:高校问答 时间:2024/05/05 05:36:13
经检测,网卡、交换机正常,网线测试通过,无线序错误,但是三者相连之后网卡和交换机指示灯均不亮,这是为什么?盼高手指点,急ing....
我们从机房到办公室引出四条线路,两路通过HUB1接办公boos系统内网,两路通过HUB2接销售系统内网。用同一台电脑测试,接HUB1上的boos系统一切正常,接HUB2的两条线路均连不上,但HUB2上连接到销售区的其他销售终端均使用正常。接到办公室的四条网线用测试仪测试全部一切OK! 使用boos和销售系统时,均正确设置了相应的IP, 关键是有一条线路连上后交换机和网卡指示灯不亮,另一条连上后指示灯间歇性闪动。所有网线绝对没问题,用测试仪测试线序完全正确!

eth0:1 Link encap:Ethernet HWaddr 00:E0:4C:E0:19:E7
inet addr:192.168.0.123 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11 Base address:0x3000

[root@localhost root]# ping 202.103.176.22
PING 202.103.176.22 (202.103.176.22) 56(84) bytes of data.
64 bytes from 202.103.176.22: icmp_seq=1 ttl=61 time=17.8 ms
64 bytes from 202.103.176.22: icmp_seq=2 ttl=61 time=14.9 ms
64 bytes from 202.103.176.22: icmp_seq=3 ttl=61 time=14.1 ms
64 bytes from 202.103.176.22: icmp_seq=4 ttl=61 time=56.0 ms
64 bytes from 202.103.176.22: icmp_seq=5 ttl=61 time=13.2 ms

[root@localhost root]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
192.168.99.0 * 255.255.255.0 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 192.168.0.1 0.0.0.0 UG 0 0 0 eth0

ping下,ip设置?

可能是你网线的线序接错了吧...交换机和网卡间用两个B线序的平行线..看你的情况你用的是交叉线吧也就是A-B线序

交换机的电源接了吗?

网线应该没问题,网卡暂时还没法说,因为交换机批示灯都没亮,说明信号还没到交换机,而听你说,交换机是好的,那就检查交换机输入信号线是否接好.